Lambretta Lifetime tanks are made of polyethylene (HDPE). Polyethylene (HDPE) is an extremely lightweight material that is resistant to ethanol. In contrast to steel tanks, rust, corrosion and fatigue of the weld seams are not an issue

Conventional XXL tanks in particular are often difficult to fit and it is not uncommon for these tanks to rest against the frame and cause excessive vibrations. They also have a considerable weight disadvantage if the walls are thick enough. The Lambretta Lifetime tank has a capacity of 12 liters and is perfect for long distance touring or fuel stop grumblers.

With the right methods, these tanks can be painted and customized, just like any modern plastic bodywork.

Installation is super easy and, thanks to the upper and lower damping buffers, solid, secure and built to last. It may be necessary to individually adjust the length of the rubber bumpers supplied to achieve a perfect fit of the tank.

Fitting the fuel tap:

• The fuel tap is a clever solution that is easy to fit, provides a greater distance between the fuel tap and silent block and makes aligning the fuel tap lever child's play. The two O-rings are made of FPM75, which is resistant to E10 and ozone.
• When you fit the fuel tap, the O-rings should never be fitted with grease. A fine film of oil is sufficient.
• The hose clamp should be tightened with a torque of 2.5 - 3 Nm. Anything else could damage the O

-ring.

Generously dimensioned cut-outs on both sides allow easy access, smooth cable routing and fit even the largest carburettors.

Advantages of the Lifetime tank:

• Impact resistant (almost impossible to puncture)
• Rust resistant (no metal to corrode)
• Ethanol resistant (will not collapse or swell)
• Light weight (possibly the lightest on the market)
• Easy to fit
• 12 liter capacityNo
• welds to crack

Since 2021 Lambretta Lifetime tanks are 

Made in Germany