CP Sledge Hammer CasaCover engine sidecasing

SLEDGE HAMMER VERSION!!!

The full list of parts used for the special version of this CasaCover is as follows :

The complete CasaCover comes with the following parts:
1  x  bare CasaCase sidecase
1  x  CNC inspection panel (choice of colours)
Set of 5mm Allen screws for CNC inspection panel
2  x  O rings for sealing inspection panel
1  x  CNC clutch operating arm  (choice of colours) + screw
1  x  CNC control cable adjuster block (choice of colours)
3  x  extended neck control cable adjusters
1  x  gasket for control cable adjuster block
1  x  clutch operating shaft
2  x  needle bearings for clutch operating shaft
3  x  circlips for clutch operating shaft
1  x  special washer for clutch operating shaft
1  x  clutch thimble for x  pressure shaft gear
1  x  oil level screw + washer
2  x  pressure shaft gears for clutch operating shaft*

*To explain the two different pressure shaft gears (see pic), these are the three possible scenarios that they cover :
1. Lambretta GP / DL type clutch WITHOUT pressure-disc nipple = A
2. Lambretta LI / SX / TV type clutch WITH pressure-disc nipple = B
3. Casa Performance PowerMaster clutch with cushdrive             = B

CHOICE OF 6 COLOUR OPTIONS FOR THE ANODISED PARTS!
Complete CasaCover with BLUE anodised parts
Complete CasaCover with BLACK anodised parts
Complete CasaCover with SILVER anodised parts
Complete CasaCover with RED anodised parts 
Complete CasaCover with GOLD anodised parts 
Complete CasaCover with ORANGE anodised parts